Aelum 2026.11.21 · x86_64

Download the Aelum ISO

This is the installer ISO. Write it to a USB drive and boot from it: the installer opens on its own and installs Aelum without needing internet.

System requirements
  • UEFI boot
  • At least 8 GB of disk space

Installation media

Fileaelum-2026.11.21-x86_64.iso4.41 GB
Verify

Check that the download is intact

Every Aelum release is signed with the Aelum release key. It is worth checking the checksum and the signature before you flash the ISO.

4.41 GB · 2026-11-21

Release assets

  • Disk imageaelum-2026.11.21-x86_64.iso
  • SHA-256 checksumaelum-2026.11.21-x86_64.iso.sha256
  • SHA-512 checksumaelum-2026.11.21-x86_64.iso.sha512
  • GPG signatureaelum-2026.11.21-x86_64.iso.asc

Signing key

Aelum Release <release@aelum.dev>728F 5F59 FB2F 5A88 C6EE28D4 930A 672A 3A1B 5B60No expiry

You can get this key over WKD: GPG fetches it from aelum.dev by email, so there is no keyserver and nothing to import by hand.

Three commands to check it

Put the files above in one folder and run these commands in it, one line each.

  1. 01

    Get the signing key

    GPG can fetch the release key directly from aelum.dev by email (WKD), so you don't need a keyserver or a manual import.

    gpg --auto-key-locate clear,wkd --locate-key release@aelum.dev
  2. 02

    Check the checksum

    Run this in the folder your downloads are in. It re-hashes the ISO and compares it with the published value.

    sha256sum -c aelum-2026.11.21-x86_64.iso.sha256
  3. 03

    Verify the signature

    This confirms the ISO was signed with the Aelum release key and has not been changed since.

    gpg --verify aelum-2026.11.21-x86_64.iso.asc aelum-2026.11.21-x86_64.iso
Writing it to a USB stick

Write the ISO to a USB drive

Any of these three puts the 4.41 GB ISO on a USB stick. Ventoy leaves the stick usable for other files, BalenaEtcher writes a single image, and dd is already available on Linux and macOS.

Ventoy

  1. Download and open Ventoy on your computer.
  2. Select your USB drive, then click Install.
  3. Copy aelum-2026.11.21-x86_64.iso onto the USB drive.
  4. Boot your computer from that USB drive.
Get Ventoy

BalenaEtcher

  1. Download and open BalenaEtcher on your computer.
  2. Choose aelum-2026.11.21-x86_64.iso as the image to flash.
  3. Select your USB drive, then click Flash!.
  4. Boot your computer from that USB drive.
Get BalenaEtcher

dd (Linux / macOS)

  1. Plug in your USB drive and find its device name with lsblk.
  2. Run dd if=aelum-2026.11.21-x86_64.iso of=DEVICE bs=4M status=progress, replacing DEVICE with your drive (for example /dev/sdb).
  3. Boot your computer from that USB drive.